Sliding Door Rollers & Track Repair
Hard to slide? Grinding or jumping the track? We replace rollers, repair or cap damaged tracks, realign panels, and tune handles/latches so your patio door moves with one hand and seals properly.
📍 Brooklyn & nearby NYC • 📆 Same-week availability
Fast Turnaround
Most doors restored in one visit
Correct Parts
Matched rollers & proper track fix
Like-New Glide
Easy one-hand operation & seal
Signs You Need Roller/Track Service
- Door is heavy, grinds, or squeals while moving
- Panel jumps track or binds
- Flat-spotted rollers / rust / seized bearings
- Dented, pitted, or mushroomed track
- Handle turns but latch doesn’t align or seal
Why Doors Get Hard to Slide
Grit, moisture, and load wear out bearings and chew up tracks. Roller height goes out of balance, the panel sags, and the latch misses. New rollers plus track repair put everything back in line.
Our Repair & Tune-Up Process
Diagnose & measure
Identify door brand/type, roller style, track condition, reveal lines, and latch alignment.
Replace rollers
Install matched steel or nylon-bearing rollers; set heights for true travel and easy start.
Repair or cap track
Dress dents, install stainless caps where needed, and correct flat spots or mushroomed edges.
Align & secure
Square the panel, set reveals, and adjust the keeper so the latch throws fully with a tight seal.
Clean, lube & test
Clean tracks, lube pivots (not the rolling surface), and test smooth operation end-to-end.
We Service
Vinyl, aluminum, and wood sliding patio doors; 2-panel and multi-panel systems; common brands (Andersen, Pella, Milgard, etc.).
Optional Upgrades
- Stainless track cap for long-term durability
- Corrosion-resistant sealed-bearing rollers
- New handle set and keeper alignment
- Weatherstrip refresh for better seal & quieter close
Make your slider glide like new
Free estimate, clear pricing, and durable roller/track repairs.
Sliding Door — FAQs
Do I need a new door?
Usually not. Fresh rollers, track repair, and alignment solve most issues for years without full replacement.
Steel or nylon rollers?
We choose based on door weight, track condition, and corrosion risk. Sealed bearings resist grit and roll smoother longer.
Will this stop drafts?
Yes—correct panel height and keeper alignment improve compression at the seals; we can replace worn weatherstrip as needed.
How long does it take?
Many roller/track jobs take 60–120 minutes per panel depending on condition and access.
Service Area
Brooklyn, Manhattan, Queens, and nearby NYC neighborhoods. If you’re unsure, just ask us.
Quick Photo Tip
For a fast match, send a photo of the bottom rollers, track profile, and latch/keeper. Use ⌘/Ctrl + Shift + S on desktop—or just snap on your phone.
Safety & Alignment
We verify smooth travel, proper latch engagement, and safe operation. No forcing or slamming needed after service.
Durability Check
Where corrosion is a concern, we recommend stainless caps and sealed bearings to extend life and reduce maintenance.